Inscrivez-vous pour débloquer vos prix B2B exclusifs et commencez vos achats. Inscrivez-vous maintenant!
Powerline repeater
Commande uniquement
EAN: 4010312324103
MPN: 31000030
Colis: 1
Prix (hors TVA)
87,14 €
par unité
Quantité minimale de commande: 1
Délai de livraison estimé à notre entrepôt: 2-4 weeks
Prix valable jusqu’au 31.12.26 ou jusqu’à épuisement du stock
Informations techniques
| État de l’article | Nouveau |
| Nom du fabricant | Powerline repeater |
| Marque | ELTAKO |
| Catégories |
Appareils bus KNX & Modbus
|
| Pays d’origine* | CN |
| * Le pays d'origine réel peut varier selon le lot de livraison. Pour confirmer le pays d'origine spécifique, veuillez contacter votre gestionnaire de compte. | |
| Code du système harmonisé | 8526 9200 00 |
| ETIM | EC000698 |
| Tension nominale | 230 V |
| Méthode de montage | Montage encastré (plâtre) |
| Système de bus KNX | Non |
| Système de bus Powernet | Oui |
| Autres systèmes de bus | Aucun |
| Système de bus LON | Non |
Détails d’emballage
| Niveau d’emballage 1 | 4010312324103, 4010312324103 |
| Niveau d’emballage 2 | 4010312324103 |
| Niveau d’emballage 3 | 4010312324103 |
Autres données techniques
| Système de bus radio fréquent | Non |
| Degré de protection (IP) | IP20 |
| Système de bus KNX radio | Non |
Téléchargements
Description
Powerline repeater. 53x43mm, 25mm deep for mounting in 58mm switch boxes. Standby loss only 0,5 watt. The repeater supports greater ranges. With cable lengths of >300m the repeater is normally located in a distributor between the sensor and the actuator. The repeater repeats commands from sensors with the same address g, e. Feedback messages from actuators are not repeated. Two rotary switches are located on the front to assign addresses: The left-hand rotary switch determines the group address g with 16 alphanumeric digits from A to P. The right-hand rotary switch determines the element address e with 16 numerical values. Above it is a slide switch which is a configuration switch with positions 0, 1 and 2. Position 0: Central commands are repeated irrespective of the repeater’s e address. With address g, e=0, only central commands are repeated. Position 1: With address g, e=0 at the repeater, all commands of group g are repeated. Position 2: Unassigned. All entries and configurations can also be accessed via the mains using the Sienna Professional PC software. Addresses can be changed live or without voltage. On the left of the rotary switches is a red LED to display all activities. Next to that is the Reset button and to the right of that is Service Pin (P). The terminals located above are plug-in terminals for conductor cross-sections of 0.2mm² to 1.5mm².