Informazioni tecniche
| Condizione dell'articolo |
Nuovo |
| Nome del produttore |
Pulse-count input, 2-way |
| Marchio |
EATON
|
| Categorie |
Dispositivi bus KNX/Modbus
|
| Paese di origine* |
CZ |
|
* Il Paese di origine effettivo può variare in base al lotto di fornitura.
Per confermare il Paese di origine specifico, contatta il tuo referente.
|
| Codice del Sistema Armonizzato |
9028 3090 00
|
| ETIM |
EC000794
|
| Sistema bus KNX |
No |
| Sistema bus radio |
Sì |
| Sistema bus Powernet |
No |
| Con comunicazione bus |
Sì |
| Altri sistemi bus |
xComfort |
| Sistema bus LON |
No |
| Sistema bus radio KNX |
No |
Dettagli dell'imballaggio
| Livello di imballaggio 1 |
4015081169498 |
| Livello di imballaggio 2 |
9008790072031 |
Altri dati tecnici
| Tipo di fissaggio |
Altro |
| Modello |
Modulo base |
| Numero di ingressi |
2 |
| Corrente d'ingresso dell'attuatore |
Sì |
| Tensione d'ingresso dell'attuatore |
Sì |
| Larghezza in moduli |
2 |
| Grado di protezione (IP) |
IP20 |
| Con indicatore LED |
Sì |
| Profondità min. della scatola da incasso |
0 mm |
Descrizione
The pulse value input 2-fold is used to set that in order to record the consumption values of, e.g., electric, gas, water, etc. via a zmeter with standardized S0 interfacez and then subsequently transfer them for evaluation and displaying to the room-manager with zenergy management functionz. The supply is carried out via a separate 24VDC power supply unit (110772 or 110773, not included as standard!!!).the 24VDC supply is fed through 2-fold at the pulse input and is therefore available for supplying the meter (if required). Notice: only use S0 sensors and observe the correct wiring!!! The device is mounted in the junction or installation box. Attention!: Does not work with xComfort Bridge . Notice: only use S0 sensors and observe the correct wiring!!! The device is mounted in the junction or installation box.