- Home /
- Accessori per illuminazione /
- Trasformatori e reattori per illuminazione /
- Driver LED /
- Touch panel for radio controller MONO, 4-zone
- Home /
- GTV Lighting /
- Touch panel for radio controller MONO, 4-zone
- Home /
- GTV Lighting +
- Accessori per illuminazione /
- GTV Lighting Lighting accessories +
- Trasformatori e reattori per illuminazione /
- GTV Lighting Lighting transformers, ballasts +
- Driver LED /
- Touch panel for radio controller MONO, 4-zone
Touch panel for radio controller MONO, 4-zone
Informazioni tecniche
| Condizione dell'articolo | Nuovo |
| Nome del produttore | Touch panel for radio controller MONO, 4-zone |
| Marchio | GTV Lighting |
| Categorie |
Driver LED
|
| Codice del Sistema Armonizzato | 8526 9200 00 |
| ETIM | EC002710 |
| Grado di protezione (IP) | IP20 |
Dettagli dell'imballaggio
| Livello di imballaggio 1 | 5902801200571 |
| Livello di imballaggio 2 | 5902801200762 |
| Livello di imballaggio 3 | 2012801297365 |
| Livello di imballaggio 4 | 2012801297303 |
Download
Descrizione
A remote light control system consists of three essential components:
- 12/24V LED driver
- Single zone controller
- Control device (remote control or control panel)
A touch panel is one of the two available control devices. The panel can be used to control 4 zones independent of each other. Many single controllers responsible for a single light point can be assigned to each zone. The panel is powered by two AAA batteries (not included in a set).
On the panel we will find:
- MASTER switch – which makes it possible to turn on and off all zones at the same time
- Slider - with which we can dim and lighten the strip
- 4 switches - responsible for activating each zone separately
- Button that delays turning off the light by 60 seconds
Zone coding
It is necessary to determine to which zone the controller is to be coded. Then we disconnect the power supply of the controller for at least 10 seconds. After reconnecting the power supply, the ON button of the selected zone should be pressed 3 times within 3 seconds. Correct pairing is signalled by the LED strip blinking 3 times.
To activate the night lighting function, that is, the maximum dimming of the LED strip, the OFF Master or OFF button of the selected zone should be held.
The panel is mounted by screwing/sticking the mounting plate to the selected surface. The mounting plate has a built-in magnet to which the control panel is attached. This solution makes it easy to replace the battery.
- Communication range up to 30 m;
- Possibility to pair 4 controllers;
- Night lighting function;
- Mounting with a magnet;
- Batteries are not included in a set.