Informazioni tecniche
| Condizione dell'articolo |
Nuovo |
| Nome del produttore |
Wireless 4-way universal transmitter module |
| Marchio |
ELTAKO
|
| Categorie |
Interruttori
|
| Paese di origine* |
CN |
|
* Il Paese di origine effettivo può variare in base al lotto di fornitura.
Per confermare il Paese di origine specifico, contatta il tuo referente.
|
| Codice del Sistema Armonizzato |
8526 9200 00
|
| ETIM |
EC001358
|
| Portata |
30 m |
| Trasmettitore radio da incasso |
No |
| Trasmettitore radio da parete |
No |
| Frequenza radio |
868 MHz |
| Con trasmettitore portatile |
No |
| Grado di protezione (IP) |
IP20 |
Dettagli dell'imballaggio
| Livello di imballaggio 1 |
4010312321386, 4010312321386 |
| Livello di imballaggio 2 |
4010312321386 |
| Livello di imballaggio 3 |
4010312321386 |
Altri dati tecnici
| Alimentazione |
Altro |
| Sistema rolling code |
No |
| Numero di comandi |
4 |
| Copertura di protezione della tastiera |
No |
| Con codificatore radio |
No |
Download
Descrizione
Wireless 4-way universal transmitter module. With internal antenna. With battery (lifetime 5-8 years). For installation. 45mm long, 45mm wide, 18mm deep. This transmitter module has four channels to transmit wireless telegrams to the Eltako Wireless Building system like a 4-channel wireless pushbutton. E1 initiates a wireless telegram such as Press top rocker of a wireless pushbutton with a rocker. E2 initiates Press bottom rocker (or right rocker of a wireless pushbutton with double rocker in each case). E3 initiates like Press left top rocker of a wireless pushbutton with a double rocker and E4 initiates like Press left bottom rocker of a wireless pushbutton with a double rocker. When the control contacts are opened, the telegram is the same as Release wireless pushbutton. The control inputs can be activated by internally placed jumpers either for pushbuttons (as-delivered state), window/door contacts or motion detectors. With a cable length up to 10 metres, conventional pushbuttons, window/door contacts or floating motion detector contacts can be connected to terminals E1, E2, E3 and E4. The opposite pole in each case is GND. The electronics is powered by an internal button cell CR2032. To replace the battery or activate battery supply, open the housing and remove an insulation strip. The housing must also be opened to select the modes. To open the housing, use a screwdriver to release the tabs on the lid and then remove the lid.