Informazioni tecniche
| Condizione dell'articolo |
Nuovo |
| Nome del produttore |
Shutters/Blinds actuator |
| Marchio |
EATON
|
| Categorie |
Dispositivi bus KNX/Modbus
|
| Paese di origine* |
AT |
|
* Il Paese di origine effettivo può variare in base al lotto di fornitura.
Per confermare il Paese di origine specifico, contatta il tuo referente.
|
| Codice del Sistema Armonizzato |
8541 4900 00
|
| ETIM |
EC001330
|
| Tipo di fissaggio |
Montaggio da incasso (intonaco) |
| Sistema bus KNX |
No |
| Sistema bus Powernet |
No |
| Numero max. di uscite per tapparelle |
1 |
| Larghezza in moduli |
3 |
| Altri sistemi bus |
xComfort |
| Comando locale/manuale |
Sì |
| Con funzione di commutazione |
No |
| Con indicatore LED |
No |
Dettagli dell'imballaggio
| Livello di imballaggio 1 |
4015082406967 |
| Livello di imballaggio 2 |
9007912841180 |
Altri dati tecnici
| Tipo di corrente |
AC |
| Numero di ingressi |
0 |
| Sistema bus radio |
Sì |
| Potere di commutazione max. |
1380 W |
| Con comunicazione bus |
Sì |
| Corrente di commutazione (carico resistivo) |
6 A |
| Sistema bus LON |
No |
| Grado di protezione (IP) |
IP20 |
| Sistema bus radio KNX |
No |
| Radio bidirezionale |
Sì |
| Modulo bus rimovibile |
Sì |
| Profondità min. della scatola da incasso |
26 mm |
Descrizione
Important!: This is a first generation Shutter actuator and we strongly recommend to use instead the latest generation slim Shutter actuator (CJAU-01/04) which has a low stand-by power and that is also available with local inputs (CJAUE-01/04-I) and as plug-type (CJAE-01/01). The Shutter actuator receives and actuates blinds and blind drives with 230V motors with integrated end position switch. In this blind actuator, 2 safety functions are possible (e.g., safety position during wind and / or rain. Lock-out protection - when the terrace door is open this roller blind / blind must not close). note: several shading motors must not be switched parallel on one blind actuator without having an isolator relay. The supply is carried out via the mains. the device is mounted in the switch or junction box. When using with inductive loads (e.g., fluorescent lamps), observe the suppressor circuit in all cases!