You don’t think about lightning until it hits — and when it does, it’s already too late. One strike, one surge, and half a control panel can fry in seconds. That’s why ABB lightning protection isn’t just another accessory. It’s insurance for your entire electrical system, the invisible barrier between clean power and chaos.
ABB builds lightning protection equipment for both buildings and industrial facilities — from roof arresters to cabinet-mounted surge blocks. It’s all about catching that violent energy and sending it somewhere safe, before it reaches sensitive gear. The logic’s simple: better to destroy a small SPD module than an entire PLC cabinet worth thousands.
The materials are pure copper and stainless steel; no half-measures. The contacts and clamps feel overbuilt because they have to be. When lightning hits, you’re dealing with hundreds of thousands of amps. ABB devices don’t flinch — they absorb, redirect, and reset.
A big part of ABB’s lineup is surge protection — systems that handle the smaller, sneakier voltage spikes that happen daily, not just during storms. Power grid switching, nearby motors, elevator starts — they all generate transients. ABB’s SPD surge protective devices respond within microseconds.
The units mount directly on DIN rails in distribution boards. Each module has thermal disconnects and visual indicators, so you can see at a glance if it’s still active. When a surge hits, the internal varistors clamp voltage instantly, turning a dangerous pulse into harmless heat. And when they’ve done their job, replacement’s quick — slide out, click in a new cartridge, no rewiring.
ABB SPDs meet the strict IEC 61643 standards, tested for thousands of impulses. They’re the quiet guardians of power quality — doing their job silently, cycle after cycle.
Other ABB products:
| Auxiliary contact connector S3-S4-S5-S6 plug-in |
| CONNECTOR FOR SOR/UVR F IEC L=2M S3-6 |
| Control Panel for UMC22-FBP |
| Indicator light E219-3EDC yellow/green/red |
| EXM16G ATEX Plastic compression gland |
Protection doesn’t stop at the panel. Up on the roof or outside the structure, ABB lightning arresters catch direct strikes and route them into the grounding system. The rods and conductors are built for long-term exposure — corrosion-resistant, UV-stable, mechanically tough. They’re not decorative metal poles; they’re engineered current highways for one of nature’s worst tempers.
Down below, ABB earthing and bonding systems tie everything together. Ground rods, clamps, copper tape, bonding bars — every connection ensures that lightning energy finds the quickest way into the ground. Proper bonding also keeps voltage differences under control, protecting people and equipment from dangerous potential rises.
A good earthing setup isn’t just safety — it’s system stability. Without it, no SPD or arrester can do its job. ABB’s kits make installation straightforward, all parts fitting cleanly, with corrosion-proof interfaces that stay conductive for decades.
Lightning doesn’t care if it’s dry, humid, coastal, or mountain weather. ABB designs for all of it. The enclosures on surge modules stay sealed against dust and condensation. The external hardware survives salt spray, ice, and heat. You install it once and it just sits there, quietly doing its work for years.
Installers appreciate that ABB keeps form factors consistent. Whether you’re wiring a small home board or a 2000-amp industrial switchboard, the devices line up neatly, labels clear, terminals robust. It looks like someone thought it through — because they did.
At Bank of Lamps, we stock the full ABB lightning and surge protection range: SPD surge protective devices, lightning arresters, earthing and bonding components, and accessories for commercial, industrial, and energy projects. We supply B2B across Europe — Germany, UK, Netherlands, Baltics, France, Spain — with stable stock and technical documentation ready.
Electricians know that lightning protection isn’t about luck — it’s about preparation. And ABB gives you the tools to stay one step ahead of the next storm.