- Sākums /
- Apgaismojuma piederumi /
- Transformatori, ballasti, draiveri /
- LED draiveri /
- Touch panel for radio controller MONO, 4-zone
- Sākums /
- GTV Lighting /
- Touch panel for radio controller MONO, 4-zone
- Sākums /
- GTV Lighting +
- Apgaismojuma piederumi /
- GTV Lighting Apgaismojuma piederumi +
- Transformatori, ballasti, draiveri /
- GTV Lighting Transformatori, ballasti, draiveri +
- LED draiveri /
- Touch panel for radio controller MONO, 4-zone
Touch panel for radio controller MONO, 4-zone
Technical Information
| Preces stāvoklis | Jauns |
| Ražotāja nosaukums | Touch panel for radio controller MONO, 4-zone |
| Zīmols | GTV Lighting |
| Kategorijas |
LED draiveri
|
| Aizsardzības pakāpe (IP) | IP20 |
Iepakojuma informācija
| Iepakojuma līmenis 1 | 5902801200571 |
| Iepakojuma līmenis 2 | 5902801200762 |
| Iepakojuma līmenis 3 | 2012801297365 |
| Iepakojuma līmenis 4 | 2012801297303 |
Lejupielādes
Apraksts
A remote light control system consists of three essential components:
- 12/24V LED driver
- Single zone controller
- Control device (remote control or control panel)
A touch panel is one of the two available control devices. The panel can be used to control 4 zones independent of each other. Many single controllers responsible for a single light point can be assigned to each zone. The panel is powered by two AAA batteries (not included in a set).
On the panel we will find:
- MASTER switch – which makes it possible to turn on and off all zones at the same time
- Slider - with which we can dim and lighten the strip
- 4 switches - responsible for activating each zone separately
- Button that delays turning off the light by 60 seconds
Zone coding
It is necessary to determine to which zone the controller is to be coded. Then we disconnect the power supply of the controller for at least 10 seconds. After reconnecting the power supply, the ON button of the selected zone should be pressed 3 times within 3 seconds. Correct pairing is signalled by the LED strip blinking 3 times.
To activate the night lighting function, that is, the maximum dimming of the LED strip, the OFF Master or OFF button of the selected zone should be held.
The panel is mounted by screwing/sticking the mounting plate to the selected surface. The mounting plate has a built-in magnet to which the control panel is attached. This solution makes it easy to replace the battery.
- Communication range up to 30 m;
- Possibility to pair 4 controllers;
- Night lighting function;
- Mounting with a magnet;
- Batteries are not included in a set.