VF1200S-G3-840-06

VF1200S-G3-840-06 used as a light source module, part of the system for illumination. Flexible application in ribbon-/hose/-strip category lighting setups, adaptable for linear installations in interior or exterior use. Electrical: Operating voltage seems stable at 24V DC. Current draw aligns with design spec under standard load conditions—check compatibility if integrating into low-power circuits. Light output rated around 4000K (neutral white), better brightness balance against cool tones, efficiency is typical but test lumen performance if needed. Physical: Build quality looks durable enough for basic project environments. Strip width approx ~12mm; neutral aesthetics fit most designs but requires careful handling during peel-and-stick mounting on uneven surfaces [risk adhesive loss]. Polyurethane encapsulation noticed — IP67 rating provides splash resistance not full waterproofing claims? LED tape cut points max every ~100mm units; could make trimming tricky for spaced applications needing fine cuts to avoid electrical mess-ups. LED density noted: high-density chips format—critical spacing calculated in this kind of series setup. Technical notes: SKU VF1200S-G3, Voltage = 24VDC, Color Temp = 4000 Kelvin, Luminous flux unspecified confirm specs at source URL, Max substrate temp tolerance unknown monitor heat dissipation closely, IP Level certified to IP67 likely polyurethane-based layer envelop covers LEDs completely ensure bonding tests redo adhesives G3-light normalize base contact sure grounding mode fixes junction clips unless reinforced tighten screws stat near extension sockets align circuitry close tightly!