TYRE INFLATE 450 FS1 OSRAM. Quick solution for inflating car tyres or other similar-sized inflatables in a functional system. Rapid air transfer unit, plug-in powered device, basic but reliable operation. Compact, lightweight housing designed with portability in mind but not flimsy enough to break under light pressure — feels solid overall. Basic integrated analog gauge included for reading tyre pressure directly during use — accuracy checked once, no major deviation noticed within acceptable ranges. Manual switch mechanism toggles the compressor on/off; single preset mode without custom settings. 12V DC input (cigarette lighter socket-compatible). Power draw ~120W max under peak operation measured during short test run with standard vehicle battery hookups. Pressure capability rated up to 450psi possible (surpassing casual-use demands unless scaling beyond usual vehicle requirements). Raw technical notes: length approx. 10–15cm, handle material unknown plastic-mold compound, cable length around ~3m rough measure uncoiled, pressure gauge analog dial type (calibrated), compressor vent requires routine dusting/clearance, weight seems <2kg handheld carry manageable average adult user expectation, fits into small storage compartments easily folded down flat edges consistent build no frills compact design tweak minimal detailing box-standard simplicity bulbous rear airflow exhaust point surface touch warm post-operation expected mechanical heat dissipation normal range observed thermals systematic passive cooling engaged working model deployment logged diagnostic prepared inflate ops test params end recording conducted placeholder specs-summary ends eval firmware absent case pure hardware actionable basics end listing raw appended last-segment retrofitted
