TFP2000S-G1-830-05 V2

TFP2000S-G1-830-05 V2 — light ribbon/strip/hose unit for integrated systems. Provides localized illumination, fits within modular setups where precise linear lighting needed. Good for environments requiring flexibility and compact integration. Power runs stable at 24V DC input, tolerates drops/surges within acceptable range. Driver not onboard – external required (standard match needed). Light output defined at ~3000K (warm white spectrum), CRI rated ~80+ basically suits general ambient applications but not ultra-high demand color accuracy stuff. Physical: Strip length 5 meters total, trims possible along pre-determined cut points marked on the strip. Profile slim and low clearance (~10mm height) practical in tight installs. Adhesive backing included seems standard quality sticking fine to clean surfaces without prep issues noticed so far, IP rating unspecified from current data-probs indoor or controlled use only. Technical notes: voltage = 24V DC nominal, strip length = 5m max, adjustable field-cuts spaced regularly along printed marker lines, LED count density = unclear # LEDs/m due missing source details – suggest manual recount onsite before spec adherence, adhesive tape factory applied no extra install hardware shown bundled etc-basic as typical setup parts apply separately purchase direct supplier etc depth care-use pending full test environ limits still vague atm esp outdoor élő failsafety checks-needed sensors/controllers too etc observed flaws replace fast turnaround recommends critical modules verification-stage point side ops gap/request update phases unknown constant reliable outputs check-test-run always ensures proper fit cross-comp final bench figure syncs clear repeatlogs routine safe panels ok norms