Универсальный механизм LED-диммера System 3000 Komfort, на 2 поста, номинальное напряжение: AC 230 V, 50/60 Hz, нагрузка: макс. 100 m

System 3000 universal LED dimming insert Komfort 2-gang Features: Two independent outputs for two lamp groups. Switching and dimming light bulbs, HV halogen lamps, electronic transformers for halogen or LED lamps, dimmable inductive transformers for halogen or LED lamps, HV LED or compact fluorescent lamps. Connecting auxiliary units is possible. Using a System 3000 auxiliary insert, 3-wire together with a System 3000 operating top unit, 2-gang, both outputs can be operated separately. Automatic or manual setting of dimming principle according to load (leading or trailing edge). Display of the selected operating mode using LED. Bulb-saving switch-on. Switch-on brightness can be saved permanently. Switch on with the last brightness set, or a saved switch-on brightness. Minimum brightness can be set. Electronic short-circuit protection. Electronic excess-temperature protection. Operation with and without neutral conductor connection. Pushbutton dimmer. Combination with RF operating top unit, 1-gang 2-gang for KNX: Sensor channel, 1-gang or 2-gang. Local control of System 3000 insert possible. Wireless control of other devices for KNX as sensor possible. Insert function selection: Adjustable dimming behaviour and dimming characteristic, soft on and soft off function, fading function, staircase function with switch-off pre-warning, scene function (16 scenes), blocking function, time delays. Auxiliary input can be used as an additional operating point for the System 3000 insert or for wireless control of other KNX devices as a sensor. Notes : In general, operating the dimmer without connecting a neutral conductor is possible, although some LED and CFLi light sources require the neutral conductor connection to prevent flickering. For operation without a neutral conductor, the minimum load for light bulbs, HV halogen lamps, Tronic transformers, and wound transformers increases to 50 W. Electronic transformers and ballast devices for LED lamps can be operated with the dimming procedure stated by the manufacturer. If the ambient temperature is higher than 25 C, the connected load must be reduced.