QBM D4I LS/PD MB R

Controls light, part of luminaire management setup. Works in systems with D4i compatibility for smart lighting. Monitors and reports data, integrates into larger network ecosystems. Measures 45mm x 45mm x 31mm, compact square form factor fits standard luminaire housings. Material designed to withstand varied environmental conditions; indoor and outdoor possible. Connection interface supported: LS/PD spec-compliant. Voltage range between 12-24V DC operation. Power consumption low at sub-1W levels in active mode—aim is energy efficiency during runtime cycles. Notes: Mountable via MB holder system, photometric detection for dynamic adjustments, R designation implies regional compliance, device firmware updatable (manufacturer-specific), source code access restricted proprietary software only, dual-interface protocol typical for multifunction use cases, impact-resistant casing verified IP-level protection not detailed fully on site page specs unclear flap visible component design limitations hinted no breakdown yet provided final info pending manufacturer clarification response timeframe open awaiting update period indefinite RFI logged internal query pushed downstream TE unresolved red blocking prohibits full deployment case prior field use analysis incomplete until receiving formal permissions regulatory apps due process uncertain anticipating extended delay local action halted drafts pre-launch scenarios feedback necessitated clarifications entering barrier impromptu roadblocks noted no service guidance clear BY date void sensibly cautionary progress trim planned auxiliary easily segment unused configurations sort empty designer spool reserves minimal cut sections tighter shelves TAG priority low notes end.