PL-LIN-Z6 550-830 140X20-LV

Light-emitting module, narrow beam design for luminaires requiring compact linear integration. Emits warm white (3000K) for ambient professional or architectural use. Fits into low-voltage systems efficiently. DC operation — low voltage driver compatible at 24V nominal input level, power measured 8W max. Module length spans approx. 140mm, width tightly restricted to 20mm zone for precise fitment in slim fixture housing applications. Diode arrays forward-optimized on the board — Z6 setup enhances lumen density/per performance ratio if coupled with suitable thermal dissipation mediums & caps operational load variance. Full capacity lumens ~550lm range; constant current driven mode preferred (reduce flicker risk). Technical Notes: – PL-type identification code: Z6 series linear form factor. – Luminous flux rating: ~550 lm @ typical drive specs. – Warm white spectrum defined as CCT = 3000K typ, CRI >80 reported baseline but situational variance possible under high-load installs. – Module dimensions exact (L x W): ~140 x ~20 mm chassis baseplate area coverage torch shape format allows stack/multiples mount edge adjacencies direct serial chain viable plan depends users setups trim req hanging frame clamp holds flexibility tighten tolerance levels absolutely critical check mounts routine inspect daily ops fail-safe install engineering docs first priority list params etc repeat calibration frequency awk periods deal actuate LED wear effect cautions appendix builder note stateOMP outlines model wiring refinement schematics keep prints file.access refs hours.confirm/core config tags fixtures.Client.DiagnosticsFAQs.ProductRef.#4052899606029