OT 200/220-240/5A6 P5

OT 200/220-240/5A6 P5. Part of LED system, it powers LED modules. Converts mains voltage to DC for operation, suitable for building lighting systems requiring stable power supply. Input voltage: AC 220–240V range, frequency 50/60 Hz depending on grid specs. Output: DC up to 200W max load, adjustable current at 5A6 peak rating — consistent delivery under varying module loads. Efficiency rated high—low heat dissipation design typical of premium drivers in the category. Physical housing durable yet compact for tight installation spaces, fits industrial environments or recessed setups without issue. Compatibility noted with certain control interfaces (PWM/dimming standards may vary per local config). Technical notes: Supports SELV (Safety Extra Low Voltage). Weight ~700g approx, light enough install manageable without bracket stress issues. Terminal block connections on both ends screw type secure but annoying tight tolerances might frustrate fast work setup users prefer wider slots panel entry routing spare allowance flex rigid cabling options cut restrictivity over time risk fails insulation wear-down halogen use proximity bad idea divert immediate designs alternative open cooling gaps airflow adjunct prevent heat traps model suffers slight temp spikes above nominal on extended highs check logs sort quarters extra.) Failures reported low across testing sample batches tolerance margins within confidence acceptable market spec level fabs constant feedback loop close issue ratio cleanest characteristic prime points here stability ruggedness good baseline.suitable permanent complex duty placement steady LEDs driving exterior/safebase ambient no-custom warning retrofits rare trending exclusions.loads monitor dim caps thresholds clearance wastes confirms,