LFP800S-G5-930-10 L1

LFP800S-G5-930-10 L1, light strip unit. Role: illumination module for integrated designs requiring flexible placement — ambient lighting or targeted accent in setups where conventional fixtures won't fit. Electrical: Requires dc input, powered by external driver setup. Voltage listed as nominal range of 24V DC, current variable depending on segment length in operation. Dimmable config possible via compatible control interface (not confirmed on-site yet). Output seems stable in trials so far. Physical attributes: Ribbon base structure is bendable to tight angles without apparent damage during a quick flex stress test. Factory-recommended cut points at marked intervals — approx spacing looks like every 10cm but re-check that before cutting anything next time! Strip width fits snug into the track we had but tabs might need trimming when installing overlays depending on bezel depth chosen. Specs: Light temp setpoint ~3000K. CRI claimed >90 not yet verified!. Total power max per meter-claimed up to 15W/m rating. Dimensions unrolled ~exact figures TBD@site measure 8mm width x less than thickness estimate visually close ~2mm material thick feels lightweight plastic backing stiff laminate top coating, adhesive type unknown sticks well glass+metal if clean surface prep tested didnt fail immediately afterward reliable hard compression install method adjustments handheld fine tools ok soft blade preferred working around solder pads end sections vulnerable avoid pressurized contact zones early iteration flaws persisted slightly evident less flaking newer batches status pending retract.).