LFP2000-G3-824-04

Provides illumination for decorative, architectural, or low-intensity lighting systems. Suitable for linear applications, flexible enough to integrate into tight spaces without breaking (unless misused). Emits even glow, assumes compatibility with standard RGB control units. Rated power supply: 24V voltage input. Current draw varies based on section length but maintains consistent efficiency within specified range under normal conditions. Encapsulation for strip fairly robust against dust and incidental moisture but not fully waterproof — don't submerge. Heat generation mild if ventilation plans considered; prolonged over-voltage conditions risk damage. Physical dimensions seem stable — approximately 2000mm in length per roll unit delivered. Width small (<8mm), accommodates restrictive installs while keeping handling manageable (silicone coating tolerates stretch but don't pull recklessly). PVC backing adhesive functional most surfaces actual loads require securing anyway. Raw technical notes:-Total wattage ~7-9W/m depending color mode.-Cuttable every 83mm sections, marked zones only.-Max brightness level ~800lm/m rated output tests ideal lab condition.-Working temp range -25˚C up to ~80˚C max verified edge case limits exceeded lifespan drops fast.-Connector type pre-soldered cable ends passive adaptors needed integration separate driver/controller-system setups straightforward solder skill helpful tighten overall function loops sturdier designs advised outdoor reliability fails quicker dependent climate details humidity affects glue bonds long-term directly placement-wise near salt always ends poorly extra shield layer better idea possible retrofits good luck experimentally ruin less replacements yard/project