LF800S-G5-865-10 L2

LF800S-G5-865-10 L2, part of modular lighting assembly systems. Emits light uniformly over a flexible surface, commonly integrated in low-profile installations requiring precision illumination—architecture, displays. Works well combined with compatible drivers and mounts. Flexible linear structure. Designed to be bent or curved slightly without damaging internals. Encapsulation minimally protective—not ideal for high moisture environments unless secured properly. Adhesive backing possible (verify compatibility before use). Difficult repair if damaged; individual diodes embedded too tightly for easy replacement. Nominal input: 24V DC power source necessary for operation—expect voltage drop under incorrect wiring config conditions, manual recommends correct termination connectors only (sold separately). Rated output ~800 lm/m at full brightness (~4000K–6500K correlated color temp window available w/factory calibration). Power consumption approx 10W/m peak draw depending dim settings + environmental factors—may fluctuate at higher ambient temperature/during continuous runtime exceeding recommendations. raw notes: item ID LF800S-G5-865-10, construction base = silicon & PCB layer composite material, diode count 120/m (avg spacing tight/conforms industry LED ribbon density standards). Runs off standard LV constant-voltage driver setups, width measures 8mm typical dimension spec no listed variances allowed install sheets/standards documents clarify adhesive strip placement errors caution adhesion solvent damage risk always apply surface prep prior routine installation avoid bubbles folds cuts improper pressure points may fail strips lifecycle prematurely esp balance uneven stresses longer walls edges decorators care needed pls follow guidelines fine print packages stapled manual check rows each batch sold matches certified inspection warranty loopholes quality control lapse או חתום QA labeling trim serial bad LEDs traceback batches.events logs maybe helpful replace units