LF200M-G3-RE-06

LF200M-G3-RE-06. It's a flexible lighting solution, fits into strip/hose systems for adaptable illumination setups, mostly indoor applications but maybe outdoor depending on conditions. Plays nice with modular integrations. Handles most standard configurations. Input voltage ~12V DC nominal (verify). Current rating unclear without intermediary test — datasheet might state 0.3A per meter but needs real-world validation under extended use cycles at peak load to confirm stability. Connector type: basic pin setup? Not lock-type—double-check fitting across template modules to avoid mismatch during assembly. Material: thermoplastic housing layer on it looks durable—slightly rigid; tensile strength feels mid-range when lightly stressed in-shop testing (<10kg pull-force experiment done casually). Adhesive backing pre-installed—seems OK unless heat buildup leads to curling or material slippage over time (~TBC post-install trials). Length spec given: full rolls come as 5m continuous, cuttable at marked points; cutting impacts waterproofing integrity? Notes: Nominal voltage = 12V DC. Stretch limit <10kg pull force approx, adhesion reliability TBD. Cut-point spacing ~5cm intervals, waterproof concern post-cut. Thermoplastic casing durability moderate-test phase waiting. Light output uniformity good visually (>90%). Power draw estimated ~0.3A/m full runtime condition stabilization pending long-run results analysis. Pin connectors simple attachment mechanism—visual check recommended before batch assembly stage. Length roll size = 200 meters per spec doc divided sections deployable @ factory marks only trim versions require calibration past edit prohibited scenario options matchreg align all feedback ignore fluatory mismapsulation still plan-debug TBA!