LF2000S-G5-930-05 L1

LF2000S-G5-930-05 L1. Light delivery unit, fits into ribbon-strip category, flexible integration for ambient or direct-output systems. Designed for modular setups requiring precise color temp control ± power consistency. Electrical: 24V input, draws approx. 9.6W/m at full load — stable efficiency % not provided but assumed high due to linear drive config (~90+%). Direct connection crimp terminals w/ polarity marker visible. External driver compatibility (check pairing chart). Physical: Strip length = 5m roll form factor pre-mounted adhesive backing (peel prep req'd). 3-step MacAdam binning visible @ close inspect judging by clean CRI execution 93 spec typical RGB warmth ratio ~3000K final spectrum tuned heavy lean warm white hot point — don’t overstretch/advisory fix every .1m section safety limit install clamp holders important! On strain stress areas tightly rigged housing min needed especially humid/wet-IP rating none/not listed Technical notes: Model LF2000S-G5. Input voltage range-nominal 24V only. Power draw ~9–10W per meter max calc, thermal management passive-only adhesive sensitive fixers req. Color rendering index (CRI) listed: "min typ." absolute ~93 specs uniformity shift ok within glance scale near default tones only adjustment possible trim cable DIY safe cutter points spaced ('every N mm no damage'). Final output temp laser calibrated target calibration matrix confirm reads baseline reported strong @ factory before ship batch verified quality note persists across inventory tags known batches strip continuation excellent diode choice reliability good block failures rare %.