LF2000-G3-SW40-04 L1

LF2000-G3-SW40-04 L1. Functions as primary linear illumination unit within modular system setups, flexible application along surfaces or enclosures, interfacing via standard mounting tracks or adhesive backing. Provides consistent light output for ambient or task-level environments. Driver required for operation, not included — check compatibility based on current draw (not exceeding max input rating). Powered by DC feed (24V), length 2 meters total, cuttable sections every 100mm with marked intervals. Wire leads pre-soldered; polarity sensitive during install—reverse bias risks damage to diodes. Physical structure: silicone housing layer overlaid above LED matrix strip for weatherproofing claims (IP65 rated but confirm sealing adequacy before exposed placement). Connection terminals pre-attached, wire gauge ~20AWG equivalent insulation intact. Mounting manual specifies use of double-sided tape included in package—works fine for smooth surfaces but may slip if overheated. Refraction angle ~120 degrees from emission points confirmed under bench testing yesterday—slight overspill reported at edges but minimal diffusion issues across zone coverage up to 90cm span noticeable direct-view inspections only. raw notes follow: rated power consumption 19 W/met, LED type unspecified SMD class – likely white-series SW40B generics, CRI >=80 spec mandatory checked ok batch code tie-in sheet ref# D30117 dated Sept'23, material tensile strength low observed bending stress failure tests tighten radius beyond mfg specs >15mm curves failures probable adjustments pending later trials cycle debugging phase