GL-HO-G1 150-840 L90X90

GL-HO-G1 150-840 L90X90. LED module built for high-output systems, wide-beam applications, architectural setups where precision light spread is key. Operates as core component in layered lighting arrays—one-to-many configurations possible without degradation. Consistent luminous flux at higher power settings, stable in demanding conditions. Specs scattered across manufacturer datasheet but pieced together here: Power consumption tightly hovers around 150W nominal at full load – varies with ambient temp though, won’t sit static if cooling’s insufficient. Dimensions roughly squared—90x90mm outline casing compact enough for modular panel installs but limits heat dissipation area unless external sink added (recommend pairing). Luminosity rated “840” range; neutral-white tone upheld throughout standard operational hours (L value solid holds near L >80 long life). Quick test showed no flicker up to limit curve on input power stability/regulation source ~12V DC region applied directly linear driver board NO secondary conversion necessary. Allows rapid setup integration DIY kits or multi-unit expansion. -Voltage: Input stable within fixed DC parameters. -Beam angle: Approx. uniform distribution from all reflectors. -Build tolerance tight: Screw mounts thread fine match specs codes GL standards unit-only category. -Weight negligible <200g total unboxed. -Thermal cut-off inline default factory config actuation temp 70°C threshold trip mandatory block-check-period intervals embedded processor triggers auto-reset re-run feasibly ≤5 min cooldown durations logged rotation special cases longer "freeze lights" feedback delayed reconnect-per-manual-tested timestamp errors not repeatable inspect further