GFDT800-G1-827-05

GFDT800-G1-827-05 ties into larger lighting systems, linear illumination use case. Ribbon/strip form factor, adaptable but fixed in application constraints. Decorative or task; depends on placement angle + luminous flux output. Available power 5W nominal. DC input, voltage rating verified—operates at 24V direct current only; check your driver specs to avoid mismatch. Length measures modular standard: 800mm total strip range -> no cutting beyond existing endpoints (structural integrity fails). IP20 protection class typical for dry interiors only, unsuitable for moisture-heavy zones. Physical profile slim (~8mm tall x ~10mm width approx)—flex semi-rigid type within manufacturer tolerance bank specs—bend warning issued per datasheet dimensions adherence max twist radius specified small. Adhesion layer backing provided fits surfaces smooth flat no undoable attempt after peel-off linkage binds hard ++ Review LED arrangement gaps tight-run output soft tone warm-white spectrum; CRI test hit stable baseline = good performance rendered spaces w/ natural definitions intact. Raw notes: Voltage 24VDC constant, Power limit 5W active, Warm white correlated color temperature set=2700K, Connection via end-to-end clip-links or solder pads integrated within termination points ribbon-style system nodes light-gap minimal alignment perfect binding edge flush install req adhesive active forever clamp-type holding surface prepped cleaned prior mount permanent status finish mode fail not removable retry adhesive layer rubber polymer data sheet defined mxTemp limits visible riding <50C spot pulse ok working ranged TXPARAM data mx align'd visual bridging semssl relaxed factory-grade ratio expanded cutoff spectral range uniform blast TRIMMED WCC ajusted normals inline full debug OK code test++. Recommended only+++