GFDS600-G1-825-01

GFDS600-G1-825-01. Provides modular light delivery in systems requiring flexible configuration for linear illumination tasks. Mounted or embedded in various setups; ribbon design aids tight, compact integration. 12V DC input voltage. Power output rated 9W/meter—consistent operational wattage across standard load parameters (single connection). Brightness specified at ~525lm per meter length, uniform diffusion layer minimizes hotspots. IP65 sealed — appropriate for damp environments but never direct submersion. Physical: Lightweight strip form, max bend angle unclear from current datasheet (appears to tolerate moderate curvature), ribbon width approx ~8mm and total thickness under 2mm including adhesive backing layer. Color temp listed "825," warm white typology ~2500k range expected; dimming compatibility via external controllers confirmed but lacks dedicated integrated driver unit—design becomes system-dependent here. Factory wire leads pre-attached — note polarity markings seem subtle visually. Adhesive backing suited only for smooth surface install without excess contaminants present—it’s average weak bond type commonly used on ribbons anyway—revisit if high-temp mounted zones planned during assembly phases just saying prob shift risk over time overheats unchecked stress grime effect that area ***** raw notes: Input: 12V DC. Power draw: 9 watts-per-meter. Brightness rate: Approx 525 lumens/m. Length units configurable (default rolls seem to hit ~5m before ship config specs change.) LED spacing not given explicitly but presumed typical (>25 LEDs per roll?!). IP65 rating condition: splash-safe only! Ribbon adhesion likely temporary w/high heat vs curve-heavy placements eventual peel probable adhesives fatigue-cycle limit.<|endoftext|>