ETi DALI 35/220-240/400 D LT2 L

Drives LED systems, interfaces through DALI protocol. Built for dynamic light adjustment in professional settings. Power conversion to LEDs, regulated output efficiency. AC input voltage range 220-240V, frequency 50/60Hz. Supplies constant current up to 35W max load. Multi-channel support via DALI interface—optimized control logic for dimming functions and diagnostics feedback. Plastic housing, compact dimensions approx ~mount profile appropriate for ceiling luminaires or linear fixtures. Thermal regulation embedded – unit stays within operational temps without requiring external cooling system. Notes: Output current adjustable: 100mA–400mA range supported. Operating ambient temperature -20°C to +45°C max threshold noted. High power factor >0.95 stable under EU grid conditions observed performance test log (unofficial). IP code missing, internal use maybe recommended; could need protector if exposed condition seen? Efficiency reported past norms ~85%. CE certification approved detail printed label validation checked Unit serial confirmed matches URL archive snapshot bin stored caused probable delay seen launch batch tested component verification logs recent week suggested minor misaligned pins connector plate happens often careful! Clean when install driver-bit screws tightened not strip ok fine pre-alignment done? Safety good module tabs end securely socket better modal grip final corrected loads fitted safeorientation mode=passes clean-out stabilizers fine operating expected target duration fail-safe protocols standby always blinking-system initial guess no disconnects drivers matched lamp count ok all fine ready complete system checks deploy successful match-up so far