- Avaleht /
- Valgustustarvikud /
- Valgustustrafod, liiteseadised /
- LED-draiverid /
- Remote control for radio controller RGBW, 4-zone
- Avaleht /
- GTV Lighting /
- Remote control for radio controller RGBW, 4-zone
- Avaleht /
- GTV Lighting +
- Valgustustarvikud /
- GTV Lighting Valgustustarvikud +
- Valgustustrafod, liiteseadised /
- GTV Lighting Valgustustrafod, liiteseadised +
- LED-draiverid /
- Remote control for radio controller RGBW, 4-zone
Remote control for radio controller RGBW, 4-zone
Technical Information
| Toote seisukord | Uus |
| Tootja nimi | Remote control for radio controller RGBW, 4-zone |
| Bränd | GTV Lighting |
| Kategooriad |
LED-draiverid
|
| Kaitseaste (IP) | IP20 |
Pakendamise üksikasjad
| Pakkimistase 1 | 5902801200380 |
| Pakkimistase 2 | 5902801200717 |
| Pakkimistase 3 | 2012801297389 |
| Pakkimistase 4 | 2012801297327 |
Allalaadimised
Kirjeldus
A remote light control system consists of three essential components:
- 12/24V LED driver
- Single zone controller
- Control device (remote control or control panel)
A remote control is one of the two available control devices. The remote control can be used to control 4 zones independent of each other. Many single controllers responsible for a single light point can be assigned to each zone.
A remote control is powered by two AAA batteries (not included in a set).
On the remote we will find:
- MASTER switch – makes it possible to turn on and off all zones at the same time
- 4 switches - responsible for activating each zone separately;
- Slider - with which we can dim and lighten the strip
- Colour slider – makes it possible to change the RGB colour
- Lighting mode selection button
- Buttons for changing the speed of the lighting modes
Zone coding
It is necessary to determine to which zone of remote control the controller is to be coded. Then we disconnect the power supply of the controller for at least 10 seconds. After reconnecting the power supply, the ON button of the selected zone should be pressed 3 times within 3 seconds. Correct pairing is signalled by the LED strip blinking 3 times.
To activate the night lighting function, that is, the maximum dimming of the LED strip, the OFF Master or OFF button of the selected zone should be held.
To turn on white colour, the ON button should be held longer.
- Communication range up to 30 m;
- Possibility to pair 4 controllers;
- Night lighting function;
- Predefined colour changing modes;
- Batteries are not included in a set.