Wireless actuator staircase off-delay timer

1 NO contact not potential free 10A/250V AC, 230V LED lamps up to 400W, incandescent lamps up to 2000 watts, off delay with switch-off early warning and switchable pushbutton permanent light. Encrypted wireless, bidirectional wireless and repeater function are switchable. Only 0.8 watt standby loss. For installation. 45mm long, 45mm wide, 33mm deep. Supply voltage, switching voltage and control voltage local 230V. Zero passage switching to protect contacts and consumers. This wireless actuator is a staircase off-delay timer and features state-of-the-art hybrid technology that we developed: we combined the wear-free receiver and evaluation electronics and a bistable relay with zero passage switching. By using a bistable relay coil power loss and heating is avoided even in the on mode. After installation, wait for short automatic synchronisation before the switched consumer is connected to the mains. In addition to the wireless control input via an internal antenna, this staircase off-delay timer can also be controlled locally by a conventional 230V control switch previously mounted. Glow lamp current up to 5mA, dependent on the ignition voltage of the glow lamps. The lighting is switched on again after a power failure provided the set time has not yet elapsed. You can teach in encrypted sensors. You can switch on bidirectional wireless and/or a repeater function. Every change in state and incoming central command telegrams are confirmed by a wireless telegram. This wireless telegram can be taught-in in other actuators, Professional Smart Home controllers and in universal displays. With the top rotary switch in the setting LRN up to 35 wireless pushbuttons and/or wireless motion/brightness sensors FBH can be assigned, of which one ore more central pushbuttons. The required function of this staircase off-delay timer can then be selected. The flashing of the LED as soon as a new setting range has been reached when turning the rotary switch helps to find the desired position reliably. NLZ = off-delay timer. TLZ = staircase time switch. + pushbutton permanent light = TLZ with pushbutton permanent light. + switch-off early warning = TLZ with switch-off early warning. + pushbutton permanent light and switch-off early warning = TLZ with pushbutton permanent light and switch-off early warning. If the permanent light function is switched on, the function can be activated by pressing the pushbutton for longer than 1 second. This function switches off automatically after 60 minutes or by pressing the pushbutton for longer than 2 seconds. If the switch-off early warning is switched on, the light starts to flicker approx. 30 seconds before time-out. This is repeated three times at decreasing time intervals. If both switch-off early warning and pushbutton permanent light are switched on, switch-off early warning is activated before automatic switch-off of the permanent light. With the bottom rotary switch, the off delay is adjusted from 1 to 20 minutes. When motion/brightness sensors FBH are taught-in, use the last FBH that was taught-in to define the switching threshold at which the lighting is switched on or off depending on the brightness or motion detected. The off delay set on the FTN61NP is prolonged by a setting of 1 minute fixed in the FBH. The LED performs during the teach-in process according to the operating instructions. It shows wireless control commands by short flickering during operation.