- Home /
- Industrial Automation /
- PLC Automation Systems /
- Bus System Devices (KNX/Modbus) /
- Fan Coil Unit and Zone controller BACnet Schneider Electric CTRL LV FCU RH BN W/WH
- Home /
- Schneider Electric /
- Fan Coil Unit and Zone controller BACnet Schneider Electric CTRL LV FCU RH BN W/WH
Fan Coil Unit and Zone controller BACnet Schneider Electric CTRL LV FCU RH BN W/WH
Technical Information
| Item condition | New |
| Manufacture name | CTRL LV FCU RH BN W/WH |
| Brand | Schneider Electric |
| Categories |
Bus System Devices (KNX/Modbus)
|
Packing details
| Packing level 1 | 3606480770067 |
Description
Fan Coil Unit and Zone Controller. Integrates with BACnet systems. Interfaces Schneider Electric's controls to streamline HVAC management for room-level temperature and humidity control.
Compatible w/ 2-pipe or 4-pipe fan coil units. Wall-mounted design, clean modern look (white casing). Used for spaces requiring balanced air handling and zone-specific tuning.
24 Vac power input, low-voltage application, no high-power load capabilities directly supported by controller — relay needed for certain fan motor wiring setups? Verify on site before install. RH sensor onboard, dual-stage setpoint adjustment possible. BACnet MS/TP built-in comms protocol — MAC address preset but reconfigurable.
Specs vary depending on FCU type in project: RS485 BACnet MS/TP connectivity range (1200–38,400 bps), factory @ 9,600 default baudrate settings unless adjusted at deployment config panel/setup menu?
Technical notes:
- CTRL LV model specified for small loads only.
- Internal RH sensor accuracy ±2%.
- Default operating temp range 0°C – +50°C.
- Max wire distance ~1,200 m per RS485 standard compliance limits.