Información técnica
| Estado del artículo |
Nuevo |
| Nombre del fabricante |
Coupling relay, 1 NO contact 16A |
| Marca |
ELTAKO
|
| Categorías |
Accesorios y piezas de montaje
|
| País de origen* |
CN |
|
* El país de origen real puede variar según el lote de suministro.
Para confirmar el país de origen concreto, póngase en contacto con su gestor de cuenta.
|
| Código del Sistema Armonizado |
8536 4900 00
|
| ETIM |
EC001652
|
| Tipo de fijación |
Carril DIN |
| Función |
Parcialmente electrónico |
| Corriente nominal |
16 A |
Detalles del embalaje
| Nivel de embalaje 1 |
4010312206683, 4010312206683 |
| Nivel de embalaje 2 |
4010312206683 |
| Nivel de embalaje 3 |
4010312206683 |
Otros datos técnicos
| Profundidad de montaje |
58 mm |
| Ancho en módulos |
1 |
| Tensión de control 1 |
8-230 V |
| Tipo de tensión de control 1 |
AC/DC |
| Frecuencia de la tensión de control 1 |
50 Hz |
| Corriente máx. de conmutación (cos phi = 0,6) |
4 A |
| Carga máx. de lámparas incandescentes |
2000 W |
| Carga máx. de lámparas fluorescentes |
1000 VA |
| Carga máx. de lámparas fluorescentes (circuito doble) |
1000 VA |
| Carga máx. de lámparas fluorescentes (compensación en paralelo) |
500 VA |
| Número de contactos normalmente cerrados |
0 |
| Número de contactos normalmente abiertos |
1 |
| Número de contactos conmutados |
0 |
Descargas
Descripción
1 NO contact potential free 16A/250V AC with tungsten pre-contact, max. inrush current 500A/2ms. 230V LED lamps up to 600W, incandescent lamp load 3300W. No standby loss. Modular device for DIN-EN 60715 TH35 rail mounting. 1 module = 18mm wide, 58mm deep. State-of-the-art hybrid technology combines advantages of nonwearing electronic control with high capacity of special relays. With the patented Eltako Duplex technology (DX) the normally potential-free contacts can still switch in zero passage when switching 230V AC 50Hz and therefore drastically reduce wear. Simply connect the neutral conductor to the terminal (N) and L to 1(L) for this. This gives an standby consumption of only 0.1 watt. If the contact is used for controlling switching devices which do not perform zero passage switching themselves, (N) should not be connected because the additional closing delay otherwise causes the opposite effect. Universal control voltage 8 to 230 V UC. Low switching noise. Contact position indicator with LED. By using a bistable relay coil power loss and heating is avoided even in the on mode. The relay contact can be open or closed when putting into operation. It will be synchronised at first operation. This relay is not suitable to feed back the switching voltage signal of a dimmer switch. Use only relays ESR12DDX-UC, ESR12NP-230V+UC or ESR61NP-230V+UC for this purpose. The electronics does not have an internal power supply and therefore no standby loss. The microcontroller is activated when the control contact closes. This switches the bistable relay to the correct direction. The bistable relay switches back either when the control contact opens or when the control voltage falls.