Información técnica
| Estado del artículo |
Nuevo |
| Nombre del fabricante |
Bus pushbutton coupler for 4 conventional pushbuttons for feedback LEDs |
| Marca |
ELTAKO
|
| Categorías |
Dispositivos de bus KNX/Modbus
|
| País de origen* |
CN |
|
* El país de origen real puede variar según el lote de suministro.
Para confirmar el país de origen concreto, póngase en contacto con su gestor de cuenta.
|
| Código del Sistema Armonizado |
8526 9200 00
|
| ETIM |
EC002466
|
| Sistema de bus KNX |
No |
| Sistema de bus inalámbrico |
Sí |
| Otros sistemas de bus |
Otros |
| Sistema de bus inalámbrico KNX |
No |
| Radio bidireccional |
Sí |
Detalles del embalaje
| Nivel de embalaje 1 |
4010312316801, 4010312316801 |
| Nivel de embalaje 2 |
4010312316801 |
| Nivel de embalaje 3 |
4010312316801 |
Otros datos técnicos
| Tipo de fijación |
Montaje empotrado (yeso) |
| Sistema de bus Powernet |
No |
| Tipo de fijación |
Fijación por abrazadera |
| Sistema de bus LON |
No |
| Grado de protección (IP) |
IP20 |
| Número de puntos de conmutación |
1 |
| Profundidad mín. de la caja empotrada |
18 mm |
Descargas
Descripción
Bus pushbutton coupler FTS61BTKL for 4 conventional pushbuttons with integrated 24V LEDs for connection to FTS14TG pushbutton gateways by 2-wire pushbutton bus. Only 0.2 watt standby loss. For installation. 45mm long, 45mm wide, 18mm deep. Up to 30 bus pushbuttons and/or bus pushbutton couplers FTS61BTKL devices can be connected to the BP and BN terminals of a pushbutton gateway FTS14TG. The permitted total line length is 200m. The RLC device enclosed with the FTS14TG must also be connected to the terminals BP and BN on the bus switch or pushbutton bus coupler furthest away. A voltage of 29V DC is supplied to the connected FTS61BTKL over a 2-wire pushbutton bus which is also used for data transfer. Please use only conventional bus or telephone lines. Up to four conventional pushbuttons T1-T4 can be connected to the 15cm long connecting cables. Each opposite pole is T0. The connecting cables can be extended up to 2m. With the 24V LEDs integrated in the pushbuttons, confirmation telegrams of actuators are displayed if the IDs of the actuators were registered into the ID table of the FTS14TG with PCT14. Caution: Do not apply any voltage. The pairs T1/T3 and T2/T4 can be defined as direction pushbuttons. Connect the bus to BP and BN. Make sure the polarity is correct.