Regístrese para desbloquear sus precios B2B exclusivos y empezar a comprar. ¡Regístrese ahora!
RS485 bus 1 and 2 level wireless repeater image 1

RS485 bus 1 and 2 level wireless repeater

Solo bajo pedido
EAN: 4010312313879
MPN: 30014019
Embalaje: 1
Precio (sin IVA)
83,25 €
por unidad
Cantidad mínima de pedido: 1
Tiempo de entrega a nuestro almacén: 2-4 weeks
Este precio es válido hasta la siguiente lista de precios o hasta agotar existencias

Información técnica

Estado del artículo Nuevo
Nombre del fabricante RS485 bus 1 and 2 level wireless repeater
Marca ELTAKO
Categorías Dispositivos de bus KNX/Modbus
País de origen* CN
* El país de origen real puede variar según el lote de suministro. Para confirmar el país de origen concreto, póngase en contacto con su gestor de cuenta.
Código del Sistema Armonizado 8526 9200 00
ETIM EC000698
Tensión nominal 230 V
Tipo de fijación DRA (adaptador para carril DIN)
Sistema de bus KNX No
Sistema de bus Powernet No
Otros sistemas de bus No
Sistema de bus LON No

Detalles del embalaje

Nivel de embalaje 1 4010312313879, 4010312313879
Nivel de embalaje 2 4010312313879
Nivel de embalaje 3 4010312313879

Otros datos técnicos

Sistema de bus inalámbrico Sí
Grado de protección (IP) IP20
Sistema de bus inalámbrico KNX No

Descargas

Descripción

1 and 2 level wireless repeater with small antenna. Only 0.6 watt standby loss. If required, a wireless antenna FA250 can be connected. Modular device for DIN-EN 60715 TH35 rail mounting. 1 module = 18mm wide, 58mm deep. This repeater is only needed if the building conditions prevent undisturbed reception or the ­distance between the wireless pushbutton and receiver is too great. Antenna FA250 with a 250cm cable or FAG55E- with a 100cm cable can be connected instead of the enclosed small antenna. When positioned in the optimal location, it can increase range considerably. The 1-level mode is activated ex works. Only the signals from sensors and actuators are received, tested and retransmitted at full transmit power. Wireless signals from other repeaters are ignored to reduce the data volume. In de-energized state it can be switched to 2-level mode with a rotary switch. After switching on the supply voltage, the wireless signals of another 1-level repeater are now being processed. A signal can then be received and amplified maximum 2 times. Wireless repeaters need not be taught-in. They receive and amplify signals from all wireless sensors within their reception area. The LEDs under the rotary switch indicate all the wireless signals detected by briefly flashing. The wireless repeater FRP14 can be installed either as a single device in a subdistributor panel. It then requires a 12V power supply from a switch mode power supply unit SNT12-230V/12V DC-1A. Or it is installed together with remote Series 14 wireless actuators and cross-wiring requires a jumper. There is no connection to the bus. It is only looped through.