Regístrese para desbloquear sus precios B2B exclusivos y empezar a comprar. ¡Regístrese ahora!
Switching relay, 1 NO contact 16 A image 1

Switching relay, 1 NO contact 16 A

Solo bajo pedido
EAN: 4010312205402
MPN: 22100002
Embalaje: 1
Precio (sin IVA)
38,30 €
por unidad
Cantidad mínima de pedido: 1
Tiempo de entrega a nuestro almacén: 4-6 weeks
Este precio es válido hasta la siguiente lista de precios o hasta agotar existencias

Información técnica

Estado del artículo Nuevo
Nombre del fabricante Switching relay, 1 NO contact 16 A
Marca ELTAKO
Categorías Accesorios y piezas de montaje
País de origen* CN
* El país de origen real puede variar según el lote de suministro. Para confirmar el país de origen concreto, póngase en contacto con su gestor de cuenta.
Código del Sistema Armonizado 8536 4900 00
ETIM EC001652
Tipo de fijación Carril DIN
Función Parcialmente electrónico
Corriente nominal 16 A
Tensión de alimentación 250 V

Detalles del embalaje

Nivel de embalaje 1 4010312205402, 4010312205402
Nivel de embalaje 2 4010312205402
Nivel de embalaje 3 4010312205402

Otros datos técnicos

Profundidad de montaje 58 mm
Ancho en módulos 1
Tensión de control 1 8-230 V
Tipo de tensión de control 1 AC/DC
Frecuencia de la tensión de control 1 50 Hz
Tipo de tensión de alimentación AC
Corriente máx. de conmutación (cos phi = 0,6) 4 A
Carga máx. de lámparas incandescentes 2000 W
Carga máx. de lámparas fluorescentes 1000 VA
Carga máx. de lámparas fluorescentes (circuito doble) 1000 VA
Carga máx. de lámparas fluorescentes (compensación en paralelo) 500 VA
Número de contactos normalmente cerrados 0
Número de contactos normalmente abiertos 1
Número de contactos conmutados 0

Descargas

Descripción

Switching relay. No standby loss. State-of-the-art hybrid technology combines advantages of nonwearing electronic control with high capacity of special relays. Simply connect the neutral conductor to the terminal (N) and L to 1(L) for this. This gives an standby consumption of only 0.1 Watt. If the contact is used for controlling switching devices which do not perform zero passage switching themselves, (N) should not be connected because the additional closing delay otherwise causes the opposite effect. Very low switching noise. Contact position indicator with LED. Same terminal connection as electromechanical switching relay R12-100-. By using a bistable relay coil power loss and heating is avoided even in the on mode. The relay contact can be open or closed when putting into operation. It will be synchronised at first operation. This relay is not suitable to feed back the switching voltage signal of a dimmer switch. The electronics does not have an internal power supply and therefore no standby loss. The microcontroller is activated when the control contact closes. This switches the bistable relay to the correct direction. The bistable relay switches back either when the control contact opens or when the control voltage falls.